03_12_Dodge_Ram_Jeep_Hemi_Chrysler_300_5_7L_6_1L_V8_Enlarged_90mm_Throttle_Body_01_qo

03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body

03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body
03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body
03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body
03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body
03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body
03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body

03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body
You may also like. 03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body. Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body. Throttle Body Finish: CNC Machined. Throttle Body Material: Cast Aluminum. Enlarged Intake Flap (90mm); Original TBI bore size 80 mm. Increased Air-Flow Over Stock Unit For Add Horsepower (2012+) And Torque. Improved Throttle Response And Acceleration. No Tune Required, Relearn Process is needed. For 2012 Chrysler 300 Throttle Body Assembly V8 6.4L. For 2012 Dodge Charger Throttle Body Assembly V8 6.4L. For 2012 Jeep Grand Cherokee Throttle Body Assembly V8 6.4L. Fits all 2003-12 5.7L, 6.1L and 6.4L applications. (Will not fit any 2013/2014 applications at this time). 1 90mm Throttle Body. Follow these instructions carefully to ensure correct fitment and operation. Disconnect the negative battery terminal. Disconnect the air temperature sensor plug and the throttle body control motor plug. Loosen the clamps on the air intake tube and air. Box, and then remove the tube. Remove the four bolts that secure the throttle body to the intake manifold. Remove the stock throttle body. The stock Oring seal will be re-used. Be sure to wipe off and debris from the gasket. Bolt on this Enlarged Throttle Body using the stock hardware. On the 5.7L Hemi Plastic manifolds, take extra care when re-installing the mounting bolts. The Speed Nut type threaded nuts can be easily stripped. Make sure the threads of the bolts are properly engaged with the nut before tightening. Re-install the air inlet tube to the Throttle Body and air box and then tighten the clamps. Re-connect the air temperature sensor and the throttle body control motor plug. Re-connect the negative battery terminal and refer to the instruction sheet for throttle relearn procedure. Gas pedal/Throttle Body idle relearn process. With the addition of the larger bore throttle body and its larger intake flap, the gas pedal and throttle body must be re-synched before starting the engine. This must be done to prevent a check engine light forincreased idleThe procedure is simple. After installation instructions are complete, please follow the procedures below. If throttle body has already been installed, please just follow steps 1-4. Disconnect battery for 5 minutes. (or use a code reader to clear any stored codes in the computer). NOTE: If this is a new install, proceed to step 2. Turn ignition key to on position, do not start the engine. Slowly depress the gas pedal to the floor, and then slowly release it. Do this three (3) times. Turn the key off. The gas pedal is now in synch with the larger throttle body. Unpaid item (UPI) complaint will be filed against non-paying buyers after 4 days. May take up to 2-4 weeks due to strict Custom Inspection. Above time are for reference ONLY. We DO NOT guarantee the arrival time. (Usually we’ll lower the value and mark the item as gift). We accept 30 days return only if item is original. The item “03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body” is in sale since Sunday, September 29, 2019. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Air Intake & Fuel Delivery\Throttle Body”. The seller is “r_motor” and is located in Guangzhou. This item can be shipped worldwide.
  • Color: Silver
  • Bore Diameter: 90MM
  • Country/Region of Manufacture: China
  • Material: Aluminum
  • Manufacturer Part Number: KD1234SR
  • Brand: Kyostar
  • Fitment Type: Performance/Custom
  • Warranty: 6 Month

03-12 Dodge Ram Jeep Hemi Chrysler 300 5.7L 6.1L V8 Enlarged 90mm Throttle Body